Click for PDF
Technical Data Sheet
Eastman TREVA™ Renew Engineering Bioplastic OP6026-71 Clear

  • Eyewear
Key Attributes
  • Dimensional stability
  • Easy polish and paint
  • Excellent flow
  • Warm touch and feel

Product Description
Eastman TREVA™ Renew engineering bioplastic OP6026-71 Clear is a new cellulose-based engineering bioplastic that offers both high performance and reduced environmental impact. Renew polymers enable a brand to reduce consumption of fossil feedstock-based plastics, achieve sustainability targets without compromise, and be a fast mover in a growing market for sustainable consumer products.

TREVA™ is chemically resistant, dimensionally stable, flows well, and has excellent flow, BPA-free and has low birefringence.

Eastman Renew polymers have been certified by International Sustainability & Carbon Certification (ISCC), a global, independent agency for tracking sustainable content in a variety of industries. Renew polymers are produced with ISCC certified circular content by mass balance allocation.

Typical Properties

PropertyaTest MethodbTypical Value, Unitsc
General Properties
Bio-based Content 48 Mass %
Specific GravityD 7921.22
Mechanical Properties
Tensile Stress @ YieldD 63849 MPa (7107 psi)
Tensile Stress @ BreakD 63848 MPa (6962 psi)
Elongation @ BreakD 63818 %
Flexural ModulusD 7901940 MPa (2.81 x 105 psi)
Rockwell Hardness, R ScaleD 785100
Izod Impact Strength, Notched 
     @ 23°C (73°F)D 256216 J/m (4.05 ft·lbf/in.)
     @ -40°C (-40°F)D 256100 J/m (1.87 ft·lbf/in.)
Miscellaneous Properties
Mold Shrinkage, normalD 9550.7 %
Permanence Properties
Water Absorption, 24 h immersionD 5702.3 %
Target Processing Conditions
Drying Temperature in a Desiccant Dryer 75 °C (170 °F)
Drying Time in a Desiccant Dryer 4 hours
Barrel Set Temperaturee 235 °C (455 °F)
Mold Temperature 85 °C (185 °F)
Injection Speed 30 mm/sec (1.2 in./sec)
Maximum Barrel Residence Time 4 minutes
Thermal Properties
Deflection Temperatured 
     @ 0.455 MPa (66 psi)D 648114 °C (238 °F)
     @ 1.82 MPa (264 psi)D 64899 °C (210 °F)
Vicat Softening TemperaturedD 1525135 °C (275 °F)

aUnless noted otherwise, all tests are run at 23°C (73°F) and 50% relative humidity.
bUnless noted otherwise, the test method is ASTM.
cUnits are in SI or US customary units.
dConditioned 4 hours at 70°C (158°F).
eWith actual measured melt temperature not to exceed 260°C (500°F).

Properties reported here are typical of average lots. Eastman makes no representation that the material in any particular shipment will conform exactly to the values given.

Eastman and its marketing affiliates shall not be responsible for the use of this information, or of any product, method, or apparatus mentioned, and you must make your own determination of its suitability and completeness for your own use, for the protection of the environment, and for the health and safety of your employees and purchasers of your products. No warranty is made of the merchantability of fitness of any product, and nothing herein waives any of the Seller's conditions of sale.

8/21/2020 9:49:48 AM